Humanoid ODM
ODM & contract development guideYour own-brand humanoid,
built in Japan.
From full bodies, joint modules and hands to control development, production and maintenance.
This guide explains how humanoid robot ODM (contract development) works and how it differs from buying an off-the-shelf robot.
HumansX accepts orders from a single prototype, with a track record of delivering prototypes in as little as 2.5 months.
Process
Four steps of ODM development
We take a robot built for your use case from requirements through production and maintenance, end to end. A single point of contact reduces rework and coordination costs.
Requirements
We organize the use case, site environment, size, safety, budget and schedule, and agree on them in a specification.
Design & Prototyping
3D design visualizes the robot, joint modules and hands are selected, and a prototype is built to verify motion and performance.
Control & software
From motion control and Sim2Real to teleoperation and data-collection environments, developed together with the hardware.
Production & maintenance
Final assembly and inspection in Japan, plus maintenance and continuous improvement after deployment.
Comparison
Off-the-shelf robot vs. ODM
Buying an off-the-shelf humanoid and building your own-spec robot through ODM each have their advantages.
| Aspect | Buy off-the-shelf | ODM (your own-spec robot) |
|---|---|---|
| Launch speed | ◎ Deploy an existing robot right away | ○ Step by step from a prototype (as fast as 2.5 months) |
| Uniqueness | Same robot as everyone else | A dedicated robot optimized for your use |
| Development freedom | Limited to the provided SDK | Design down to joint control and firmware |
| Fit for the site | Based on standard specs | Size, exterior and safety tailored to your site |
| Intellectual property | Belongs to the manufacturer | Rights to designs and drawings can be set by contract |
| Maintenance | Mainly handled by overseas manufacturers | Assembly, inspection and maintenance in Japan |
* We also propose a phased approach: start validating with an off-the-shelf robot, then move to ODM for your next-generation model.
FAQ
FAQ
Can we order just one unit?
Yes. You can start with a single prototype and move to small-batch or full production based on the validation results.
How long does development take?
It depends on the specifications, but we have delivered prototypes in as little as 2.5 months. The schedule is clarified during requirements definition.
How is the cost estimated?
We quote either for the whole project or per phase (design, prototyping, production, etc.).
Can you help beyond hardware?
Yes. We also support software and control development, including motion control, Sim2Real and teleoperated data-collection environments.
Is maintenance available in Japan after deployment?
Yes. In addition to final assembly and inspection in Japan, we provide maintenance and continuous improvement after deployment.
Contact
Tell us about the robot you want to build
It's fine if your use case or site conditions aren't fixed yet. We'll start by organizing the requirements together and present feasibility, schedule and cost estimates.